Remove NVMe M.2 SSD from PC

NVMe M.2 SSD with Label Removed Before Installation

Remove NVMe M.2 SSD from PC.
How to Remove a NVMe M.2 SSD from a PC.

Amazon links

As an Amazon Associate I earn from qualifying purchases:

How to remove a NVMe M.2 SSD from a PC. Uninstall M.2 SSD from a PC or laptop and upgrade storage on PC or laptop by replacing the NVMe drive.

Video

In this video, I’m going to show you how to safely remove a NVMe M.2 SSD from your PC or laptop. Whether you’re upgrading your storage or troubleshooting a hardware issue, knowing how to properly remove the NVMe M.2 SSD is essential.

How to Remove the NVMe Drive

I’ll guide you through the steps to ensure you remove the NVMe drive without damaging your device or the SSD.

NVMe M.2 SSD with Label Removed Before Installation
NVMe M.2 SSD with Label Removed Before Installation

Preparing your device. Make sure your PC or laptop is turned off and unplugged from any power source. If you’re working on a laptop, remove the battery if it’s detachable. This step is crucial to avoid any electrical damage or static discharge that could harm your components.

Get the necessary tools. You’ll need a small Phillips-head screwdriver, and in some cases, a plastic prying tool might be helpful for opening the laptop casing.

For PC users, open the case by removing the screws on the side panel. Carefully slide the panel off to access the internal components. Locate the NVMe M.2 SSD, which is usually secured with a single screw at one end. Use your Phillips-head screwdriver to remove this screw. Gently lift the SSD at a slight angle and slide it out of the M.2 slot.
You might have to remove the graphics card (GPU) to get access to the m.2 NVMe slot.
I have 2 m.2 NVMe slots and the NVMe SSD drive I want to remove is the slot under the GPU.

For laptop users, turn the laptop over and locate the screws that secure the back panel. Remove these screws and gently pry off the back panel using a plastic tool if needed. Find the NVMe M.2 SSD, typically held in place by a small screw. Remove the screw and carefully lift the SSD at an angle to slide it out of the slot.

Tips

Some important tips to keep in mind during this process.
Handle the SSD by its edges to avoid touching the connectors, as static discharge can damage the drive. If you’re planning to reinstall the SSD or upgrade to a new one, ensure that the replacement drive is compatible with your device.

Remove NVMe M.2 SSD Label Before Installing

Should You Remove the NVMe M.2 SSD Label Before Installing in an Enclosure or Heatsink?


Comments

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.